A device to detect urinary incontinence due to loss of bladder control.
Category: Material Science Archive
A high-resolution fluid deposition system for use with Waveguide-Enhanced Raman Spectroscopy sensors.
The Nanostructure AR coating project aims to Investigate and model nanostructure AR coatings on OptiLayer and OptiRE software.
This Xerox-sponsored project aims to completely separate high viscosity PDMS and heptane via a solvent evaporation process followed by supercritical carbon dioxide extraction.
Alissa DeRubertis, Colin Ikei, Bryan Schellberg, Mark Volkin
The URMC Kidney Model Optimization Project aims to create a polymer material that can simulate the human kidney for practice by surgical residents.
Bimpe Isafiade, Harshita Mahaseth, Natalie Ramesh, Baris Eser Ugur
This project was to design an accelerated testing system for Harbec, Inc to evaluate gaskets in the India Mark II hand pump for installation by the Ugandan Water Project.
Dan Allara, Oion Akif, Paul Irving, Tessa Ludwick
In this project, a lab-scale chromatography process was developed to purify crude LUV dye. Upon scale up at Eastman Kodak Company, the chromatography process would be able to purify 2 kg/day.
Quinton Dang, Waad Magram, Zhiwei Wang
This project aims to design and build a multi-channel reverse water gas shift reactor system that allows for exploration of heterogeneous catalysis.
Ahmad El Gazzar, Thien Hung Nguyen, Clive Onyango, Emilio Vega-Ramos
The Rossell Hope Robbins Library is underutilized by many students on campus due to the lack of awareness of the library and its resources. To promote awareness for the library, this project contains designs for a “life-size” portable chess set with medieval themes.
Development of polymers to simulate kidney tissues for surgical training of medical students at UR Medical Center.
We are designing a device that will provide a cost-effective method for characterizing whether a particle in water is a plastic or nonplastic, as well as categorizing the subtype of plastic. The device will need to be effective on a scale of approximately one to five microns, which is the size of the microplastic particles.
A renewed focus on environmental concerns means that fuel efficiency and emissions of engines are of significant importance. A current design for a mixing nozzle exists, but the fuel residence could be higher and the pressure drop could be lower. A longer fuel residence time ensures smooth distribution of fuel and a more efficient burn. A lower pressure drop means that less energy is lost by the motion of the fluid through the mixer.
Helmets in the NFL are not effective enough to safeguard the health of the players. Players sustain concussions which can not only bench them, but leave life-long brain damage from the accelerations experienced during impact. As part of the project to improve the helmet, simulations were used to test material properties of different components of football helmets, such as hard foams, soft foams, and the shell. Data from the simulations were analyzed with performance metrics provided by the NFL.
Optimize creation of composites combining under-utilized hemp fabrics with epoxy.
Ten-μ solutions plans to introduce time and cost savings to the operating room (OR) through application-specific single-use instrumentation. Our instrument will allow surgeons to position and tension vessel loops at their discretion.
Identify Near Infrared transparent polymers to simulate human tissue for surgical training applications at UR Medical Center.
Characterize LiDestri Food and Drink portfolio of spaghetti sauces to optimize manufacturing process.
Identify inexpensive process for in-house purification of motion picture film dye for Kodak.
Create building materials for developing countries from waste plastic and biochar, and compare to concrete standard.
Test and identify novel gasket polymers to extend operation of Ugandan Water Project-installed India Mark II handpumps serving millions of people fresh, clean water.
Controlled, rapid-cooling chamber for initiated chemical vapor deposition of thin film polymers.
Analysis of organic light-emitting diode (OLED) chemical solutions’ inkjet printability through range of solution concentrations.